WTB: 3x00 PS pump, Alternator, A/C (for an LX9)

[pocket-rocket]

Superdave mentioned that on my swap thread. The MPFI RWD brackets are different than my TBI brackets. If I could find a full set, that would be an option for sure. There are pros and cons to both.

The RWD brackets would be most similar to the Trooper layout and and I could use the same power steering pump and A/C connections, but I don't possess them and they're a little harder to find. Gives me the option of rotating the intake 180º if that proves best.

One of the main reasons I mentioned it. Too bad it's winter and browsing the junkyards isn't much of an option at the moment.

[Canyonero]

don't have the lines but the pulley is on it and it does look like it would bolt up. as would the a/c in the front there by the oil filter. want a pic?

Yes please.

I'm a little foggy on where/how that compressor bolts on, and what that means for my RWD motor mounts.

[Canyonero]

Or maybe go with a RWD timing cover and go with Camaro/Firebird accessories kind of like the hybrid guys?

Superdave mentioned that on my swap thread. The MPFI RWD brackets are different than my TBI brackets. If I could find a full set, that would be an option for sure. There are pros and cons to both.

The RWD brackets would be most similar to the Trooper layout and and I could use the same power steering pump and A/C connections, but I don't possess them and they're a little harder to find. Gives me the option of rotating the intake 180º if that proves best.

The FWD setup is lower profile, leaves more room to work with at the front of the engine. But I would not be allowed to rotate the intake 180º. Not such a big deal if I'm going to modify the plenum for a side inlet. However that leaves the thermostat at the rear of the engine.

[Rootie524]

don't have the lines but the pulley is on it and it does look like it would bolt up. as would the a/c in the front there by the oil filter. want a pic?

[Canyonero]

Turns out I was incorrect, I do have a timing cover that will take a power steering pump. Would yours bolt up to mine? Have the pulley and lines as well?

[Rootie524]

i have a 3400 timing cover, power steering pump, and a/c compressor. lmk if you need anything.

[slinky]

I have a 3100 timing cover as well if that would work for you

[pocket-rocket]

Or maybe go with a RWD timing cover and go with Camaro/Firebird accessories kind of like the hybrid guys?

[Canyonero]

I don't see where the PS pump would mount. Am I out of luck unless I get a timing cover from a PS equipped engine?

[pocket-rocket]

You are probably right on the electric assist steering. There were a few vehicles from about that year that got it. Malibu was another one coming to mind.

[slinky]

I have an alternator in like new condition, used for about 2 months, paid $105 for it at advance auto, make me an offer email me at phel0z@yahoo.com

[Canyonero]

I'm working on an LX9 swap. I'm trying to figure out my accessories. I'd like to get my hands on a power steering pump that will fit. Doesn't appear one came on this LX9 from an '05 Uplander (electric?).

It would complete the system if I could also find an alternator and A/C compressor.