3500 width! Urgent help!!

[bob442]

so... your blocking off the TB and ploping that in the middle of the intake? it would be easier to build one from that point...

[kwhauck]

I just measured 9 7/8" on a 3400 lower from outside port to outside port. HTH

Thanks!! Looks like this shall work fine then.....

http://www.wbodystore.com/grandprix/Replacement-Intercooler-Heat-Exchanger-p-117.html#

[bszopi]

I just measured 9 7/8" on a 3400 lower from outside port to outside port. HTH

[bszopi]

Hmm... And of course, all of the CAD files I have here at work only only 1 side... I do have one plenum design I was working on, but the dimensions seem to small. But, if you want it anyway, its ~7" from outside to outside. Like I said, seems a little small to me, but there is a good chance that it is correct.

[kwhauck]

I don't have that either, my spare motor is at the machine shop for mockup.....

[bszopi]

Just measure a lower intake manifold from the outside of the port to the outside of the port (opposite side). Its going to be the same dimension.

[kwhauck]

Don't want to drive to a junkyard tomorrow unless I know its gonna work.

What is the width measurement I have in the photo....across the manifold.

Thanks!! Kyle