Need Help: Where Does This Go?

[Luang]

If it's white and it has a sweet smell and it's more moist than usual, it's probably likely that the head gaskets have gone. In a worse case scenario a head could have cracked, but on the 3x00 I've yet to see a cracked head.

If the smoke is like what I described, you could rent a coolant system pressure tester and pump up the cooling system while cold and then hot and see what sort of differences it makes. I had a minivan in my garage once (Mercury Villager aka a Nissan Quest in disguise) that had a moist exhaust and wouldn't kick any heat out of the heater (so maybe check the heater for heat as well). Turned out to be a bad head gasket.

It's not a sweet smell like a BHG I had one on my supra and that was hell. Its a light burning smell

[pocket-rocket]

If it's white and it has a sweet smell and it's more moist than usual, it's probably likely that the head gaskets have gone. In a worse case scenario a head could have cracked, but on the 3x00 I've yet to see a cracked head.

If the smoke is like what I described, you could rent a coolant system pressure tester and pump up the cooling system while cold and then hot and see what sort of differences it makes. I had a minivan in my garage once (Mercury Villager aka a Nissan Quest in disguise) that had a moist exhaust and wouldn't kick any heat out of the heater (so maybe check the heater for heat as well). Turned out to be a bad head gasket.

[Luang]

What color is the smoke and what does it smell like?

White smoke that just seeps out of the exhaust for like 5 min after the car is off and into the rear wheel well and bumper. Its a burning smell not like oil never smelt anything like it before.

[HOYS]

What color is the smoke and what does it smell like?

[Luang]

Ok now I think I got a big problem. The car will not start till I crank it a couple times and pump the gas pedal. Also there seams to be something burning because when the car is off lots of smoke come out of the tail pipe and the smell is something ice never smelt before. I think it's time to junk this van and get them another one

[TechRod]

Not required on newer PCMs (ie, 3x00s).

Thanks Brad, I didn't know that.

[Luang]

Is anything on the throttle body extremely against being soaked in water and degreaser?

[Luang]

Not required on newer PCMs (ie, 3x00s).

Thanks

[Luang]

Disconnect the TPS and see if the idle is fixed. Or if you have something that can show you the throttle percent, i.e. a scanner of some sort, check to see what it is. Should be zero at idle.

Disconnecting the TPS will throw a code for low TPS voltage, but the computer will report the throttle position at zero.

Just did that and no change

[bszopi]

Idle relearn?

Not required on newer PCMs (ie, 3x00s).

[Luang]

Idle relearn?

how do i do that

[TechRod]

Idle relearn?

[HOYS]

Disconnect the TPS and see if the idle is fixed. Or if you have something that can show you the throttle percent, i.e. a scanner of some sort, check to see what it is. Should be zero at idle.

Disconnecting the TPS will throw a code for low TPS voltage, but the computer will report the throttle position at zero.

[Luang]

Maybe check your throttle cable then. It could be hung up on something, or check the cruise module and linkage hookups on the TB itself for binding and possibly causing the TB plate to be stuck partially open.

Checked and both cables are loose

[pocket-rocket]

Maybe check your throttle cable then. It could be hung up on something, or check the cruise module and linkage hookups on the TB itself for binding and possibly causing the TB plate to be stuck partially open.