Tweet
Hey all I just took out my 3.4 with getrag 5 speed out of my car and rebuilt it and then put it all back in and was ready for some fun when the clutch made a terrible noise.. apparently I neglected to put the release bearing in correctly. this one pulls the clutch springs instead of depressing them and i never hooked the bearing into place now it just flops around, looks like i get to take the whole motor and transmission out again..... By the way if you have the notion to buy a haynes or chilton manual for these cars .. DO NOT BOTHER they are both missing mountains of info on important procedures and each book is different in nearly every torque spec... one book will say 80 ft lbs the other will say 60 or 100 just buy a gm shop manual and save some time for you extra money
Comment