327 rods in a 3.4?

[AaronGTR]

Or you have to have the anti-rotation tangs machined into the rods and caps and use the 60* bearings.

Off Topic: Chief, did you end up getting that Crane you were spying?

That's what I also heard. Tejohnson did that with his motor. Used 5.7" SBC small journal rods and had them narrowed to fit the crank and had them notched to fit the stock 3400 bearings.

You just have to have custom pistons made to fit the wrist pins if you go this route. That's what I would like to do eventually with mine.