1.6 roller rockers

[torq455]

if your v6 is a 3100/3400 FWD 94 and up, yes, everything is the same. it's heads are a direct bolt on. if you have heads with the pedestal mounts in them, it'd be a good idea to obtain the roller rocker arms.

[grandpxigtx]

what cars are good donors/and what tunning can i do to get the most out of the upgrades?

[grandpxigtx]

1.6 rockers

if your v6 is a 3100/3400 FWD 94 and up, yes, everything is the same. it's heads are a direct bolt on. if you have heads with the pedestal mounts in them, it'd be a good idea to obtain the roller rocker arms.

i doing the head job & notice that my rockers are pedestal mount no roller so what car do i go get them from or what do i need to do to make my magnumn rollers work with little or no mods?

[torq455]

why so determined to install the magnum rockers? you already have a 1.6 ratio. if you are going to install the magnum rockers, you'll need rocker studs and pushrod guide plates. you can talk to Crane or Comp cams for the correct thread size. these magnum rockers...i've never heard of them for our V6's. you sure they are for the correct engine?

[grandpxigtx]

i got them from jbody performance web site about 2 yrs ago & just got around to doing the job since i'm laidoff from work.

[Doug Guilds]

My Magnum roller tips are actually off of a small block chevy engine. I had to get ARP rocker studs and poly locks to make em work. If I had to do it again I would just get the stock GM 1.6's cause there is no adjustments needed for the stockers.