Turbo project = installed ;)

[tejohnson]

so put a nice 3" downpipe behind that and it should be great!

Actually, no room for 3", had to go with 2.5" due to space. Also had to go above the rear manifold rather than below due to the xover and the rear tranny mount in the way.

[tejohnson]

Update:

http://groomlakelabs.com/grandamp/scans/run_7_99_turbo_ga_real_run.csv

A few runs where I easily achieve full 10PSI of boost. Both wheels spin. Even after shifting into second. At the moment the downpipe is a real PITA on some the the electronics cables, and I am awaiting a new MAF since I pulled the screen from mine when I was NA. (yah, yah... I know...)

[2M6]

Very cool! Good work for sure.

[v6h.o.]

That looks really good Todd.

Very nice work! Good to hear its finally running and done!!

[z24turbo93]

Looks really nice and clean. Nice work. Is that angle for the oil feed and return line good??? I always thought it should be straight up and down or at a very slight angle.

Well anyway looks good, get it tuned now.

[tejohnson]

Looks really nice and clean. Nice work. Is that angle for the oil feed and return line good??? I always thought it should be straight up and down or at a very slight angle.

Well anyway looks good, get it tuned now.

It actually drains really nice with the -10AN line. I too was a bit concerned, however, when I pulled the turbo last night no oil really came out

[timg]

That looks great!

Tim

[TurboGTU]

Excellent!

[tejohnson]

Well, not WOT run on video yet, I am still caring for the tranny a bit:

Yes Brad, it is now above idle

http://groomlakelabs.com/gallery/video/night_run_20050521.avi

For those whom have nagged for video. Beware: 19mb d/l

[AaronGTR]

Awesome man! Looks like it's accelerating pretty good there (with a little tire spin ). Can't really hear the turbo too well in that vid, but I did here the BOV a couple times, and the exhaust sure sounds nice.

[tejohnson]

Awesome man! Looks like it's accelerating pretty good there (with a little tire spin ). Can't really hear the turbo too well in that vid, but I did here the BOV a couple times, and the exhaust sure sounds nice.

Thanks, unfortunately the lack of wheel spin is due to me lifting off the gas a tiny bit. Otherwise, I spin them halfway through second gear.

Funny too, looking at the vid on the second run I actually may have went up to 90. I just wanted to hear the BOV...

[tejohnson]

Since Jeremy (Germ) bugs me on a daily basis to get video of WOT, I decided to give in... Mainly since I am getting ready to tune the upper RPMs, and higher speeds.

Video (~18mb):

http://groomlakelabs.com/gallery/video/Evening_Logging_Session.wmv

There are two runs of significance... The first coming towards the camera. I ease into WOT (I think). Log:

http://groomlakelabs.com/grandamp/scans/20050524-003.csv

The second, with the camera in the car again, not WOT. I had to ease off after the shift to avoid breaking the wheels loose. You will hear the chirp. Log:

http://groomlakelabs.com/grandamp/scans/20050524-004.csv

KR is manageable, but does need work... Max 2.5° on the first, and max 3.8° on the second...

[forteen3gt]

WOW! Nice Vid! I am sure you are in the 13's! Spinning thru second and a scratch into gear. SWEET!

how long till you hit a track with that beast!

The BOV sounds like a few pesky STI's around here!

[tejohnson]

Soon enough... Need a WBO2, and to make more changes to torque management.

[imported_germ]

need more video