If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
proceed to the Forums area and select the forum that you want to visit.
I use a wire wheel and a drill.. works every time.
I used a wire wheel too, but it was an old one that was well broken in, so as not to gauge the block. I used a couple of cans of the Permatex gasket remover, and used a shop vac to get the dust out of the cylinders. I flushed the oil and coolant afterwards.
Comment