3100 running rough

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • himsa669
    • Dec 2009
    • 13

    #16
    thanks for the input will check out tomorrow. only had the car a week. dad drove it from california it was his parents. as far as i know only routine maintenance was done and it has a rebuilt tranny in it. 137k on the clock. do you think i could have shorted something out with the amp install or is this unrelated? its just weird it runs excellent when it starts it holds a smooth idle and revs awesomely but only in park lol. going to take a look inside the collum as well maybe something getting shorted out by the shifter when its moved.

    Comment

    • himsa669
      • Dec 2009
      • 13

      #17
      also noticed if the brake is pressed in it will kill the car as well. wtf? power steering pump makin little noise when cold and i little low on fluid bout to top her off. what could the brakes be doing to kill the car? i checked all over for vacuum leaks as well.

      Comment

      • bszopi
        Site Coder
        • Apr 2000
        • 9181

        #18
        Brakes are vacuum controlled (big hose going from the manifold to the brake booster), therefore when you press on the brakes, it puts a load on the engine. Almost sounds like your IAC valve might be bad.
        -Brad-
        89 Mustang : Future 60V6 Power

        Follow the build -> http://www.3x00swap.com/index.php?page=mustang-blog

        Comment

        • himsa669
          • Dec 2009
          • 13

          #19
          where is the valve located? is there a way to test it?

          Comment

          • himsa669
            • Dec 2009
            • 13

            #20
            also just noticed i can grab the top of the belt and move the tensioner a couple of inches very easily. is this normal?

            Comment

            • primesuspect
              ...and the plot thickens
              • Nov 2009
              • 25

              #21
              def not normal.

              Comment

              • himsa669
                • Dec 2009
                • 13

                #22
                replaced iac and same results. goin to replace belt. fights a little longer with the new iac though before it dies.

                Comment

                • himsa669
                  • Dec 2009
                  • 13

                  #23
                  alright figured it out a couple days ago. started tracin all the grounds and found the tail light ground to be loose. tightened it down and it ran fine! thanks for the help

                  Comment

                  • Azrael
                    Accelerating uphill in OD
                    • Apr 2005
                    • 763

                    #24
                    Glad to hear it was an easy fix.
                    1995 Grand Am SE

                    Comment

                    Working...