95 3100 UIM/LIM on 3.1 MPI

[943100Base]

First off i dont want any flames on this. Im only doing this cause i can get what i want for cheap. Im not concerend about the gen3 3100/3400 stuff yet, just this. I dont even have anything like that around where i am. So the 95 3100 is the next best thing i can do.

I want to put the upper and lower intakes from a 95 3100 onto my 3.1 mpi, and was curious if this can be done without swapping the heads? My motor only has 109k miles on it, so im not swapping out a good motor. i just want some more air flow into the engine.

Will the 95 3100 UIM and LIM fit the multi-port motor without any mods?

[geldartb]

dont remember but i think you might need the heads too.

[bszopi]

There are several things you have to modify to make it work, including PS lines and possibly pump, timing cover, heads...

[3400-95-Modified]

if your going to do all that get the pre 2000 3400 top end or a 2000+ 3100 or 3400 top end... it will flow more.

[GPXSS]

The ports do not line up right, you will need the heads too, and you will have to re-route some wiring under the plenum.

[943100Base]

if your going to do all that get the pre 2000 3400 top end or a 2000+ 3100 or 3400 top end... it will flow more.

Im not concerend about the gen3 3100/3400 stuff yet, just this. I dont even have anything like that around where i am. So the 95 3100 is the next best thing i can do.

As i said, the 3400 isnt availble around me and im not paying $250 for another motor i dont need.

[943100Base]

The ports do not line up right, you will need the heads too, and you will have to re-route some wiring under the plenum.

Thanks, thats what i needed to know Guess i'll have to leave it alone for now, and then worry about it later.