pushing the evelope of the 3500

[Driver_10]

:P

Header flanges, or accy brackets first?


Using the pipes from the link I told you about, right? 1.625" outside diameter?

I know that we talked about this earlier today, but just to confirm:

Go ahead and do the header-flanges first. They will need to accomodate a 1.65 primary. A 1.625 isnt quite large enough.

[ForcedFirebird]

Well, the stainless isn't here yet and the mill was open....

[ForcedFirebird]

[Driver_10]

Beautiful work as usual. Im always surprised by your level of craftsmanship.

PS I like your quote.

[ForcedFirebird]

[Driver_10]

Its Looking really good.

It should really start looking nice when the final pulleys are added. I cant wait to see how they look installed.

[Guest]

sory but what are those brackets for?

[rallen]

would it be easier to make a fwd block fit my truck and tranny or sould I just do a 3.4? aluminum heads? Make a manifold? use a 3.9 Caddy block and heads?