valvetrain clearances?

[speedvisioncavalier]

if i was to put in a reground roller cam into a 3x00 block, and use crane gold roller rocker arms, wouldnt i be able to use the stock pushrods since those rocker arms are adjustable?

also, would i need to grind a slight amount of clearance on the lower intake manifold? i have seen some articles on this in the FAQs, but i wasnt sure when that mod needed to be done.

[Doubt_Incarnate]

i think you can only adjust to a ceartain point, then the geometry is all out of whack, but i have them on a gen 2 motor and i used stock pus rods. everything looks cool to me. i dont have anyidea on the manifod clearance tho

[geoffinbc]

You will be ok as far as adjustment goes. Yes you will have to grind clearance on the lower manifold.

Here is the one Lloyd and I did http://members.shaw.ca/betterthanyoutoo/intake.jpg