Header flanges? (Now ready for Sale!!!)

[geoffinbc]

No but again if I have a drawing I can make em. Name your metal.

[gboogie99]

can i get a set of flanges for $45 shipped? for a 1995 3100...

[gboogie99]

mild steel 3/8"

matter of fact I only need 1 for the rear since nobody does reasonable turbo manifolds

[geoffinbc]

If I get a drawing then I can have 100 made in 2 days and as many as you need shipped in 3 days. I dont have a drawing though.

$45 is ok for me. Sounds fair for a pair

[RebelGT]

I think Steph has SS genII or genII flanges she's trying to unload.

[tejohnson]

mild steel 3/8"

matter of fact I only need 1 for the rear since nobody does reasonable turbo manifolds

Not quite true: http://www.donkeypunchperformance.com/store/

[gboogie99]

nice site, but they dont show any headers on there at all...

[tejohnson]

nice site, but they dont show any headers on there at all...

By themselves, no. Otherwise, look at the turbo kit. They are not "headers" as much as you would call them "exhaust manifolds". And you can get the headers only, just not directly through the store.

Based on how you were talking, I was under the impression you were only going to replace the rear. I would suggest you replace both...

[gboogie99]

who is Steph and how does one contact her?
I will contact donkeypunch and see about their headers.

[RebelGT]

Steph, she's on this forum, her nick is spacecadetz26 I think

[spacecadetz26]

I have some SS flanges available. $99 a pair basically trying to recover cost. made from 3/8" 302 Stainless and they were laser cut. I will get a pic of them mounted on a head. These have 1 5/8" primaries.

[spacecadetz26]

1st

[spacecadetz26]

....

[tejohnson]

Depending on how the headers are constructed & welded you can warp even 1/2" flanges. I have not had any issues with warpage of my headers...

[gboogie99]

ok, these must be what i heard about in the other thread... they look good