*This is just the start of the list, more to come!*
I have lots of parts that need a new home! Still have lots more to list, but I will update...
15 results in 0.0051 seconds.
-
Lots of parts looking for new homes! All must go!
-
7484 Forged 3500 crank $40 +shipping
I have a used 3500 crank for sale that was sitting in a block for the last two years for sale. Had it inspected at the machine shop and they said it needs... -
Interesting LNJ/LX9 article
It was bugging me that I couldn't re-prove to myself why I thought the LNJ 3400 and LX9 3500 were basically the same engine. After more digging I found... -
3500 3.5L (LX9) aftermarket
Does anyone know where I can find aftermarket parts for a 3500 3.5L LX9? CAI, throttle body spacers, headers etc? This would be for a 2005 Chevy Uplander.... -
Equinox and 3500 shared parts?
I'm trying to figure out if my 2005 LNJ 3400 from an Equinox shares the heads and lower intake manifold of the LX9 3500. I did find this thread
... -
What can I do to this engine.....?
I have a 2003 Grand Am. I am planning on doing some performance modifications a little bit at a time.
I would like more horsepower at the wheel....Last edited by PerfectCreature; 02-04-2011, 01:17 PM. -
3400 LIM gasket with 3500 head upgrade
I have the classic LIM leak with oil in the coolant at 112k on my 2004. What started out as a repair has turned into a 3400 with 3500 top end upgrade.... -
3400 engine, 3500 heads, 10:1 compression?
I did some searching and found some approaches, but not exactly what I'm looking for.
http://60degreev6.com/forum/showthread.php/4555... -
Crank Trigger Ring for 3500 crankshaft...WHERE?
Hey, just wondering if someone could point in the direction of where to find a Crank Trigger Ring for a 3500 crankshaft that convert it to the 3.4L 60*... -
New pushrods for head swap?
When swapping 3500 heads on to a 3400 are custom length pushrods required or are the dimensions close enough to the same that it wouldn't be required?... -
motor mount locations
i did a search on this, havent been able to find anything....
i need to know if the 2.8l block mounting holes would lineup with the mounting... -
whats needed 2.8 to 3500swap
well i havent been here for a while as everything has been working fine and been too short on cash to afford to mess with working stuff, till the otherday... -
3.4/3500 hybrid for Fiero
Brand new to the forum here so keep that in mind, I have done some research but am looking for advise on my current ideas. Here we go:
... -
CR Calculator Problems
Just bringing this up incase it hasn't been mentioned. But the 3500 default values do not work and you cannot input negative values for the piston deck... -
Good/Bad news for DR TC sets
The good news is the billet double roller TC sets are done except for the clearance gages.
The bad news is that in my attempt to minimize...
