Changed my mind again

[SappySE107]

I can't wait to tune that sucker:P I hope the IAC/equal vacuum on each cylinder won't be a problem. If it is, aftermarket ECM so you can tune each cylinder will be pretty much the only way to go IMO. Wait and see I wanna see it up close. Heck, keep track of everything cause there may be a few fiero owners wanting this setup if you care to duplicate it. (one of those might be me unless the 3400 goes in the GP).

[CNCguy]

how much time do you have wrapped up in the 6TB project so far?

I have quite a few hours in this set-up but most of them are designing, programming and fixturing. If everything works out okay, I may make more of them in the future.

Ben... I am planning on having a common manifold that will connect all the runners just below the throttle plates. The manifold will be fitted with the IAC and provide a source for MAP and modulator vacuum. I hope this will provide even airflow at or near idle speed and make tuning a little easier. Only time will tell.

Marc

[1988GTU]

That just looks to cool.. haha

[farmerz24]

is that like a blazer 2nd gen rwd front timing cover on there?

[IsaacHayes]

I was thinking, anodize the parts a color, but then, the shiny bare aluminum looks great, maybe clear anodize or clear coat it instead. If any color anodize, orange would be cool with the black chasis.

[StudlyCamaro]

is that like a blazer 2nd gen rwd front timing cover on there?

looks like a RWD car's cover to me... looks identical to one from a camaro3.4L

[CNCguy]

I was thinking, anodize the parts a color, but then, the shiny bare aluminum looks great, maybe clear anodize or clear coat it instead. If any color anodize, orange would be cool with the black chasis.

I am still undecided on how I will finish the TB's but I'm leaning towards polish, clear coat then mount them on a black powder coated LIM. The air filter covers will be ball milled, polished and clear coated.

is that like a blazer 2nd gen rwd front timing cover on there?

It's a RWD cover that I plan on using to clean up the top of the motor. I don't need the PS mount and will be moving the alternator to the AC compressor's old location. Side motor mounts will be made to eliminate the old mount and dogbones. The rear valve cover will be replaced with a front cover until I get around to making a set of billet ones.

[EspanolaGuitarista]

Wow!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! !!!!!!!!!

We are not worthy! Tuning will be a bitch!

[El_Diablo]

so what ever happend to the old plenums?

[RidgeRunner]

Marc, that's hot.

[CNCguy]

so what ever happend to the old plenums?

Which plenum... the stock 3400 or the fabricated one? Both are here but I haven't decided what to do with em.

Marc, that's hot.

Thanks man... Hope I can get it done soon since the cruise-ins are starting up.

[RebelGT]

thats sweet dude, whats the enclosure going to look like to pipe in the boosted air?