3x00 cam

[gectek]

is that stock cam cast iron?

[SappySE107]

Yes it is.

[gectek]

so would it be better to use it or are there any gains from a cam milled from some other material?

[SappySE107]

The material isn't going to give you any losses or gains. Using a press on lobe cam isn't something I would do or sell which is why I have the solid cams listed on the store. I might start offering regrinds as well.

[gectek]

so you have a few cam specs in mind? if so, id buy it all from you. im lookin at getting quite a bit of stuff, but gotta wait til the middle of jan. funding of course.

[SappySE107]

Yes, I am working with a place right now on getting some specs done up.