Reground roller CAM For sale

[NateD4]

I have a stock roller reground cam for sale from a 3400 engine. If you are interested let me know i can get you the full specs on the regrind.

[SappySE107]

How could anyone be interested without specs?

[NateD4]

I had no idea if anyone would be interested. I'll post the numbers on the end of the cam. If anyone is seriously interested let me know, I'll do some digging to find out who reground it and what the complete specs are. And if need be I'll put it in a block and get some degree wheel specs.

[imthegr8_1]

i may be interested depending on price and specs

[NateD4]

Price: make an offer. It is a reground factory cam that has not been run since it was ground.

Specs:
260 Adv. Duration
112 degree centerline
210 duration at 0.050" cam lift

Lift is probably around 0.490" I'm hoping to validate that soon.

[imthegr8_1]

hmmm...let me know when you know for sure....would you take $100 + shipping?...let me know man

[NateD4]

Hopefully this weekend I can degree it.

I was hoping to get more then that for it.

[2.8-350TBI]

Cant you measure the lift by measuring the difference between the base circle and the outer circle and multiplying by rocker ratio?

[NateD4]

Yes, I can do that. I normally use a degree wheel and dial indicator. I'll get the lift numbers tonight sometime.

[NateD4]

Lift at the cam is 0.310"

With 1.5 ratio rockers this is 0.465"
With 1.6 ratio rockers this is 0.496"

I think 0.496 is about as much lift as can be had with a gen III head.