transmission replacement

[94GPGTP]

let us know how it goes.. what hoses are u dissconnecting?

[techgeek27]

Ok thanks again for help guys... u never let us down..

I am just doin a swap .. as u all know, or may not, this is just my daily driver..

I am going for the swap out the bottom..

got the sucka UP there.. and is waiting for me..

what a job just getting it up LOL

so i disconnected what i could from the top first disconnecting hoses and what not.. taking out the air filter.. now for the freakin sub frame...great.. thanks for the details i will see what i can do...

[gpse3400]

You can also pull it out the top if you aren't feeling to remove the frame. the engine will have to come out first though.

[94GPGTP]

First Buy a engine holder that holds the engine in the car while you remove the subframe.. It has 4 contact points 2 on each side of the strut towers and 2 on the core support.. Get the car in the air use large jackstands get the bumpers about as high as your knee or higher.. Brake loose the ball joints get them out of the socket, tie up the tie rods from the tie rod to the spring with wire, remove cv nut and take cv's out.. Undo the trans cooler lines from trans and move aside,, take out starter and undo flywheel bolts, push flywheel into trans to clear torque converter wehen removing, remove electronic connections, remove 2 bolts that hold the rack on the subframe, undo all nuts that hold the engine mounts and trans mounts.. by now all that is attached to the subframe is nothing.. take out the 4 bolts that hold the subfame on and take that out.. then the engine and trans are hanging there.. get a jack and put under the trans.. 5 bolts go into the motor and easy to get to and remove but 1 goes into the trans and you need alot of extensions and get it from the passenger side.. Once all the bolts aare loose pop the trans off the pins and take down.. remove the trans from the jack and slide out from under the car.. installing it is just going backwards from removing.. Any questions just ask.. hope that helps..

Make sure you do not let the rack fall thats y wire holds it up on both tierods ..
I did it on the floor 2 times and in the air on a lift 2 times so its cake for me..

[94GPGTP]

If your looking for advise to sawp the trans with a newer one i can help.. I swapped out 4 trans and it gets faster and faster everytime i do it..

[techgeek27]

Hi everybody, its me again...

a while back i did a 3100 --> 34000 engine swap.... on my 1995 buick skylark...

It is doin great... the transmission... not so well..

I have replaced the fluid and filter, at well past 100,000 miles, i know my bad, cause it was having major slipping issues..

THat worked for a while.. now it is completely dead.. no gears at all no r, drive, 1st and 2nd.. Nutttin.. no clunk no nutthing...

so i am looking to replace it..

i have one that i can get.. but am wondering how the heck to replace it.. does anyone have a good idea of how to do this???

I know this is off of the "V6 60 degee" subject... but you have all helped sooo much before...

Let me know.. Thanks