If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
proceed to the Forums area and select the forum that you want to visit.
Have to install new intake manifold gaskets,91 Camaro engine, have to remove the push rods, been told there is no adjustment on the valves, and there is, how do I do this? Thanks
Go to Comp Cams website for a walkthrough on adjusting hydraulic lifters. Only they say to add 1/2 turn after zero lash. On our stock studs you must add at least 1 full turn.
Comment