2005 Chevy Equinox 3400 coolant in enine oil

[andytk5]

You are probably going to be better off finding a used engine and dropping it in.
Check http://www.car-part.com and see what you can find with low miles.

Yeah it's looking like that fellas, still going to check out the machine shop just to make sure but I found one for $750 30mi away, bout the cost of a rebuild kit and I don't have to fool with it

[bszopi]

I just looked at my 3500 crank in the garage, and it doesn't have any markings similar to what you are showing on it. Oddly, it actually sent a rod through the oil pan, and bent another one into a crescent moon shape. Not sure on the cause, as I picked it up on ebay as a bad short block several years back.

[andytk5]

Going to check two engines across town..

[andytk5]

was there any warranty or recall for this engine based on GM's faulty coolant and gasket design? I have heard there was a case by case basis going on but nothing official.

Yeah I have no idea about those crank marks, never seen that on any motor before either. Thanks for checking your crank for me too.

[bszopi]

http://www.girardgibbs.com/dexcool.html

Doesn't look like you'd be eligible though...

[andytk5]

yeah I see, thanks for the info though. Looks like parting this thing out may be a viable alternative and just going with a new car.

[andytk5]

couple engine across town, some are pontiac torrent engines. How can I find out the interchangeability of these engines. I mean if it only requires swapping intakes and oil pans then no sweat. Are there any computer interferences dropping a 2006 torrent motor into my 05 NOX? , should I swap my sensors?

[bszopi]

Can't look it up right now, but I'll check out what changes came about for that engine between 05 and 06. It should be a relatively easy and direct swap though. I'll be able to look up the differences in a couple hours and post them up.

Droid via Tapatalk

[bszopi]

The 2006 Torrent engine will be a direct swap with a 2005 Equinox.

http://archives.media.gm.com/us/powertrain/en/product_services/2006/whats%20new/06%20truck%20eng/06%20_PWT_3.4%20LNJ.pdf

[andytk5]

Thanks so much for that info man! I haven't posted back since I have been installing that engine actually, i have the engine in and just finishing the last bolts and wiring connections, One question though guys... Where can I fill the trans fluid and check the level?? I spilled some tanny fluid before and now need to top it off. I guess this is one of those trans that isnt owner serviceable but Im sure there is a way. Thanks so much guys!

[andytk5]

Everything is good except dash lights are flashing and have a car/lock symbol blinking, car must thing it is getting stolen. Gotta figure that out then all is good..