Exhaust header flange?

[tubov6cav]

Does anyone know where to get a exhaust header flange for a 3500 other than milzy motorsports?

[ericjon262]

http://www.britishcarconversions.com/shop/all/header-flanges-3x00-detail

[tubov6cav]

Thank you!

[tubov6cav]

So I got a chance to look at those and I'm not sure how well it'll work, I can only get the pipe that I want in 1", 1- 1/2", 1-1/4", and 2"...

[caffeine]

You can't get 1 3/4?

[tubov6cav]

Not the pipe I'll be using. And I really want to use this pipe for what I'm doing.

[Superdave]

What pipe are you wanting to use?

[tubov6cav]

The pipe I posted a picture of above.

[Superdave]

Must be a blocked site, I can't see it here at work.


There are plenty of places that sell bends in all sorts of configurations.

[tubov6cav]

These are butt weld fittings that I'm using. So it'll be one elbow and two tees then a reducer on the end of the last tee to dump into the crossover.

[3400-95-Modified]

Your limiting yourself by using schedule 10 pipe fittings... Just get J and U exhaust bends in whatever diameter you need and make your own headers completely...

[tubov6cav]

Yes I am limiting myself I know. But I really want to make this work I know someone did it. Just not sure who this guy is.

[ericjon262]

that wouldn't be hard at all to make out of 16 ga header pipe.

[tubov6cav]

If yiu looked he use one long radius 90° and two tees. That's what I want to do.

[ericjon262]

you can do it that way, but it will either be way big or on the small side. I would strongly recommend header pipe of the right size.