no start after lim

[Hell_raiser]

i have chaged that twice with no change

[Hell_raiser]

dose it need the rear nuts? i lost them lol need to find some that fit.

[TDIXON]

can you see if it will through any codes

[Hell_raiser]

nah i dont have a scan tool

[TDIXON]

no rear nuts not needed

[TDIXON]

know anyone with one? autozone will loan them out.

[Hell_raiser]

thx also it coughs like one willl fire or just backfire

[TDIXON]

walmart carries some nice obd2 scanners for 70.00 to 100.00 bucks i got one from there and works awesome.

[TDIXON]

my book says malfunctioning emission system,bad timing,faulty fuel injection system,vacumm leak at injectors,intake manifold or vacumm lines or sticking valves.

[Hell_raiser]

come to think of it i used my egr off my old cutless that would not start! i wounder

[TDIXON]

thats part of the emissions plus iidr these engines have different size intake and exhaust pushrods you didnt mix a couple by accident. that would cause a backfire.

[Hell_raiser]

nah i doubt i laid them out in a line the rockers are the same correct
?

[TDIXON]

yes rockers are the same but pushrods are different

[Hell_raiser]

ok i laid them out in a row so they should be good

[TDIXON]

i would probably take covers off and check to see if al valves springs are at the same height. but remember you woill have to crank it cause a couple valves should be open and by cranking just a bit for them to close to check spring height on those.